• Soft-start prevents nuisance tripping and prolongs element life.
• Easy to install.
• Can be installed indoors or out.
The Infresco-S 6kW is part of a family of controllers designed to provide energy saving when used with quartz halogen infrared heaters or other heating and lighting products. The ‘S’ soft-starts the load either when power is applied to the unit or by the use of a remote switch. The microprocessor controller-based unit incorporates zero-voltage switching and a soft-start function to eliminate the high initial inrush current of the heaters. This increases heater element life by up to 30%, while preventing nuisance-tripping on heavily loaded circuits. Installation of the unit is simple, and once installed is maintenance-free. The soft-start circuit is initialised each time power is supplied to the unit. Alternatively, a remote switch or heater time programmer can be added using terminals (INPUT COM) on the PCB. (in normal mode the terminals are fitted with a link, this will need to be removed and switch wires fitted). If these terminals are used an additional gland will be required to maintain the units IP rating (additional gland is supplied).
Electrical supply: 230Vac ± 10% 50 Hz.
Supply fusing: 20LCT or MCB20A (1pole, 440V) recommended or equiv.
Switching capacity: 6kW max.
Quiescent power consumption (control circuit): 50mA.
Terminals: 2.5mm2 rising clamp.
Operating temperature range: -20 to 40°C.
Protection Rating: IP65.
Cable entry glands: 3, accept cables up to 2.5mm2 dia.
Enclosure Dimensions: 100 x 60 x 100 mm (wdh).